Cycle Startup (Sw 6.2 And Higher); Machine Data - Siemens SINUMERIK 840D Programming Manual

1
12.97
11.02
1.7

Cycle startup (SW 6.2 and higher)

1.7.1 Machine data

The following machine data are used for the cycles.
The minimum values for these machine data are
given in the table below.
Relevant machine data
MD No. MD name
18118 MM_NUM_GUD_MODULES
18130 MM_NUM_GUD_NAMES_CHAN
18150 MM_GUD_VALUES_MEM
18170 MM_NUM_MAX_FUNC_NAMES
18180 MM_NUM_MAX_FUNC_PARAM
28020 MM_NUM_LUD_NAMES_TOTAL
28040 MM_NUM_LUD_VALUES_MEM
This information applies to Siemens standard cycles
only. The relevant values have to be added for user
cycles. When using ShopMill or ShopTurn, comply with
the information relevant to these products.
The following machine data settings are also
required:
MD No. MD name
20240 CUTCOM_MAXNUM_CHECK_BLOCK
The machine data files are delivered with these
defaults by the machine manufacturer.
It is important to remember that a power ON must be
performed if these machine data are changed.
Axis-specific machine data MD 30200: NUM_ENCS
must also be noted with respect to cycle CYCLE840
(tapping with compensating chuck).
© Siemens AG, 2002. All rights reserved
SINUMERIK 840D/840Di/810D Programming Guide Cycles (PGZ) – 11.02 Edition

1.7 Cycle startup (SW 6.2 and higher)

General
Minimum value
7
20
2 * Number of channels
40
500
200
25
Value
4
1
1-53