Siemens SINUMERIK 840D sl Programming Manual page 114

Measuring in JOG
4.2 Workpiece measurement
Enter details in input form
• Select of the ZO
• For rectangular pocket, rectangular spigot:
• For hole, circular spigot:
• For spigots only:
• For hole, circular spigot only:
• Enter the set position required for the reference point P0 (center) for the selected ZO in
Result
Measurement is performed automatically as soon as you press "NC Start". The probe probes
4 points of the inside and outside wall in succession.
The offset is then automatically calculated. If the selected offset is the active ZO, then this is
automatically activated.
Display and correction
After completion of calculation and offset, the diameter or width/length and the coordinates of
the center P0 are displayed.
An offset is applied in the translation components of the selected ZO in both axes.
Note
• The rejection, repetition, and end of measurement are described in the "Reject, repeat,
• A support function is available to the user when activating the determined ZO correction
See also
Rejection and repetition of measurements (Page 4-35)
General information (Page 4-38)
4-26
Enter approx. length (1st axis of operating plane) and width W (2nd axis of operating
plane).
Enter the approximate diameter.
Enter infeed value DZ (measuring depth as from starting position, value >0).
Enter the probing angle if measurement is not to be paraxial.
both axes.
end of measurement" chapter.
in the JOG mode. This is shown right after the measurement and is detailed in the
Measuring workpieces chapter, "Support of set-up in JOG - after measurement".
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles