Channel-Oriented Bits; In Data Block Gud6.Def - Siemens SINUMERIK 840D sl Programming Manual

9.2.7

Channel-oriented bits

9.2.7.1

In data block GUD6.DEF

_CHBIT
Channel bits
Changes valid after value assignment
Data type BOOLEAN
Significance:
_CHBIT[0]
CHBIT[1]
_CHBIT[2]
_CHBIT[3]
_CHBIT[4]
_CHBIT[5]
_CHBIT[6]
_CHBIT[7]
_CHBIT[8]
_CHBIT[9]
_CHBIT[10]
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Min. input limit: -
Protection level: -
Measurement input for workpiece measurement
0: measurement input 1
1: measurement input 2
Measurement input for tool measurement:
0: measurement input 1
1: measurement input 2
Collision monitoring for intermediate positioning
0: OFF
1: ON
Tool offset mode with tool measurement
0: first-time measurement (determining geometry)
1: remeasuring (determining wear)
Mean value for workpiece measurement with automatic tool
correction (_EVNUM>0)
0: no mean value derivation over several parts
1: with mean value formation and calculation
Inclusion of empirical value (_EVNUM>0)
0: subtraction of actual value
1: addition to actual value
Tool offset mode for workpiece measurement with automatic
tool offset
0: Offset in wear
1: offset in geometry, delete wear
For additive and setup offset and _CHBIT[8]=0:
0: Offset in additive offset
1: offset in set-up offset, delete additive offset
Measured value offset in CYCLE994
0: use of trigger values of the probe _WP[k,1] ...
1: use of the active ball diameter of the probe _WP[k,0]
Offset mode for workpiece measurement with automatic tool
offset
0: additive, setup offset according to _CHBIT[6]
1: offset additive in set-up offset, irrespective of _CHBIT[6]
currently not assigned
Measuring result display
0: OFF
Data description
9.2 Cycle data
Max. input limit: -
Units: -
Applies as of SW SW 3.2
Preset default
0
1
1
0
0
0
0
0
0
0
0
9-31