Measuring Cycles for Turning Machines
6.2 CYCLE982, CYCLE972 Tool: Measure turning tools
N60 CYCLE982
N65 G0 SUPA X240
N70 SUPA Z300
N99 M2
6.2.2.3
Operational sequence
Position before measuring cycle call
The calibration tool must be prepositioned as shown in the figure.
The measuring cycle calculates the center of the probe and the approach paths
automatically and generates the necessary traverse blocks.
Position after end of measuring cycle
On completion of calibration, the calibration tool is _FA from the measuring surface.
6-10
;Calibration in plus Z direction
;Approach change position in each
axis
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles