Settings In Data Block Gud6 - Siemens SINUMERIK 840D sl Programming Manual

Data description
9.3 Data for measuring in JOG
9.3.3

Settings in data block GUD6

The channel specific arrays _JM_I[ ], and _JM_B[ ] in data block GUD6 are used for
adaptation to the requirements of the machine
N92 DEF CHAN INT _JM_I[10]=SET(0,1,1,17,100,0,0,0,0,0)
_JM_I[ ]
INT value field for JOG measurement
Changes valid after value assignment
Data type INTEGER
Significance:
_JM_I [0]
_JM_I [1]
_JM_I [2]
_JM_I [3]
_JM_I [4]
_JM_I [5]
_JM_I [6]
_JM_I [7]
_JM_I [8]
_JM_I [9]
9-46
Min. input limit: -
Setting for the workpiece probe number
0: set by _JM_I[1]
1: Specified as with ShopMill
G17 plane: Workpiece probe number 1
G18 plane: Workpiece probe number 2
G19 plane: Workpiece probe number 3
Probe number and probe type for workpiece measurement only if
JM_I[0]=0
Probe number for tool measurement
Plane
17: measurement in G17 plane
18: measurement in G18 plane
19: measurement in G19 plane
Each other value: Measurement made in the plane defined by the
machine data
Definition of the active ZO on measurement
0: Measurement made with G500
1...99: Measurement made with settable ZO defined
G54...G57 or G505...G599 where
1: G54...4: G57
5...99: G505 ...G599
100: Measurement made with ZO defined in machine data
0: Standard compensation (measuring only, basic reference,
settable ZO)
1: Extended compensation (additional global and channel-
specific basis frame)
Internal copy of _JM_I[4]
Reserved
Reserved
Reserved
Protection level: -
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Max. input limit: -
Units: -
Applies as of SW SW 5.3
Preset default
Measuring cycles
0
1
1
17
0
0