Corner Measurement With Specification Of Points - Cycle_961_P - Siemens SINUMERIK 840D sl Programming Manual

Measuring cycles
Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

Parameter
Parameter
_SETV[0]
_SETV[1]
_ID
_STA1
_INCA
_KNUM
_SETV[4]
_SETV[2]
_SETV[3]
_PRNUM
7.2.4.15

Corner measurement with specification of points - CYCLE_961_P

With CYCLE_961_P
Softkeys
measuring variants 117 to 118 for CYCLE961 can be parameterized.
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
7.2 Measuring cycle support in the program editor (up to measuring cycles SW 5.4)
Type
Value
INTEGER
INTEGER
REAL
>0
REAL
>0
REAL
>0
REAL
REAL
<>0
INTEGER
≥0
REAL
REAL
REAL
INTEGER
>0
Meaning
Selection: Outside or inside corner
0...inside corner / 1...outside corner
Selection: Number of measuring points, 3 or 4
Distance between starting point and measuring point 2, without
sign
Distance between starting point and measuring point 4, without
sign
Retraction path in 3rd axis (applicate), for outside corner only,
without prefix
Enter approx. angle between 1st axis (abscissa) and 1st edge,
clockwise with negative prefix
Enter angle from 1st edge to 2nd edge of the workpiece,
clockwise with negative prefix
ZO number
For 3 measuring points only:
Selection: Offset
1
Measured corner entered as zero point
2
measured corner is offset in 1st axis by the value from
_SETV[2] and entered as zero point
3
measured corner is offset in both axes and entered as zero
point
4
measured corner is offset in 2nd axis by the value from
_SETV[3] and entered as zero point
For 3 measuring points only:
Offset of coordinate origin in 1st axis (abscissa)
For 3 measuring points only:
Offset of coordinate origin in 2nd axis (ordinate)
Probe number
Miscellaneous functions
7-21

Advertisement

Table of Contents
loading

Table of Contents