Adaptation Of The Measuring Cycles To Previous Software Versions; General Information; Measuring Cycle Subroutines - Siemens SINUMERIK 840D sl Programming Manual

Adaptation of the Measuring Cycles to Previous
Software Versions
12.1

General information

Parameter _SI[1] in data block GUD6 is used to adapt measuring cycle versions up to SW 5
to previous NC software versions.
In the delivery status of the measuring cycles, the current software status of the control is
sntered in parameter _SI[1], i.e. 5 for SW5. This parameter must be changed to match the
measuring cycles <SW 6 to older software realeases.
Example:
When using measring cycles status 5.x.x on a control with SW 4 _SI[1] = 4
Precondition:
To use the measuring cycles, the software status of the control must be ≥ 3.
12.2

Measuring cycle subroutines

General information
These measuring cycle subroutines are called directly by the cycles. With the exception of
CYCLE100, CYCLE101, and CYCLE116, these subroutines cannot be executed by a direct
call.
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0CA0
12
12-1