Siemens SINUMERIK 840D sl Programming Manual page 124

Measuring in JOG
4.2 Workpiece measurement
detailed in the Measuring workpieces chapter, "Support of set-up in JOG - after
measurement".
The "Px stored" softkeys are then switched inactive and it is possible to start new
measurement.
The number of softkeys Px is determined with the measurement task.
When the input screen form is exited, a measurement is also completed/interrupted.
Note
A mode change is only possible after exiting the operator area "measuring in JOG".
Example
Vertical softkeys P1 to P4 active,the "calculate" softkey is displayed:
4-36
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles