Siemens SINUMERIK 840D sl Programming Manual page 401

Display result displays
The result displays contain the following data:
Calibrating tool probes
• Measuring cycle and measuring variant
• Trigger values of axis directions and differences
• Probe number
• Safe area
Measuring the tool
• Measuring cycle and measuring variant
• Actual values and differences for tool offsets
• Safe area and permissible dimensional difference
• T-, D-number
Calibrating workpiece probes
• Measuring cycle and measuring variant
• Trigger values of axis directions and differences
• Positional deviation during calibration in the plane
• Probe number
• Safe area
Workpiece measurement
• Measuring cycle and measuring variant
• Setpoints, actual values and their differences
• Tolerance upper and lower limits (for tool offset)
• Compensation value
• Probe number
• Safe area and permissible dimensional difference
• T number, D number, and DL number or ZO memory number for automatic offset
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Miscellaneous functions
7.4 Measuring result screens
7-35