Siemens SINUMERIK 840D sl Programming Manual page 92

Measuring in JOG
4.1 Overview
• General machine data for machine cycle runs
• Special machine data and other data for measuring in JOG
• Interrupt for starting the ASUPs
• Data blocks and measuring cycles in general
• Special files for measuring in JOG
Detailed function description:
See "Data description, data for measuring in JOG" chapter and information on upgrading
measuring cycles in the "Commissioning" chapter and in the SIEMENSD.TXT file of the
software supplied.
See also
Modifying the GUD7 data block (Page 9-41)
General information (Page 10-21)
4-4
These machine data are described in the "Data description, general machine data for
machine cycle runs" chapter.
These special data and settings are described in the "Data description, data for
measuring in JOG" chapter.
As of PLC-SW 6.1, interrupt number 9 applies. 8 applies before this.
This interrupt must not be used by any other application during "measuring in JOG".
– The data blocks:
GUD5.DEF and
GUD6.DEF
in directory DEFINE of the software supplied have been loaded into the control and
activated (directory "Definitions" in the file system).
– The measuring cycles in directory CYCLES of the software supplied have been loaded
into the standard cycle directory of the control and a power-on has been performed.
– All files in directory JOG_MEAS\CYCLES of the software supplied have been loaded
into the control via "Data in" and a power-on has been performed.
– Data block GUD7_MC.DEF in directory JOG_MEAS\DEFINE of the software supplied
has been adapted and loaded into the control.
Data block GUD7.DEF has been activated.
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles