Siemens SINUMERIK 840D sl Programming Manual page 300

Measuring Cycles for Turning Machines
6.3 CYCLE982 tool: Measure turning and milling tools
Measuring cycle CYCLE982 returns the following values in the data block GUD5 for tool
measurement:
Parameter
_OVR [8]
_OVR [9]
_OVR [10]
_OVR [11]
_OVR [12]
_OVR [13]
_OVR [27]
_OVR [28]
_OVR [29]
_OVR [30]
_OVI [0]
_OVI [2]
_OVI [3]
_OVI [5]
_OVI [7]
_OVI [8]
_OVI [9]
Note
Tool types
During measurement or calibration, the tool type (tool parameter DP1 in the tool offset data)
of the active tool is evaluated.
Type 5xy: Turning tool or calibrating tool
Type 1xy: Milling tool
Type 2xy: Drill
Use of tool types 711 to 799 is also possible. These are treated as a milling tool (type 1xy).
From measuring cycles SW 6.3, drill (type 2xy) also with SD 42950:
TOOL_LENGTH_TYPE=0 can be gauged (refer to Chapter "Measuring drills – special
applications"). Otherwise this is only possible for drills and milling tools with SD 42950:
TOOL_LENGTH_TYPE=2.
6-24
Data type Result
REAL Actual value length L1
REAL Difference length L1
REAL Actual value length L2
REAL Difference length L2
REAL Actual value for radius
REAL Difference for radius
REAL Zero offset area
REAL Safe area
REAL Permissible dimensional difference
REAL Empirical value
INTEGER D number
INTEGER Measuring cycle number
INTEGER Measuring variant
INTEGER Probe number
INTEGER Empirical value memory
INTEGER T number
INTEGER Alarm number
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles