Siemens SINUMERIK 840D sl Programming Manual page 490

Adaptation of the Measuring Cycles to Previous Software Versions
12.2 Measuring cycle subroutines
Programming
Cycle Function
CYCLE100 Activate logging
CYCLE101 Deactivate logging
CYCLE102 Measuring result display
CYCLE103 Parameter setting in interactive mode
CYCLE104 Internal subroutine: Measuring cycle interface
CYCLE105 Internal subroutine: Log
CYCLE106 Internal subroutine: Log
CYCLE107 Output of measuring cycle messages
CYCLE108 Output of measuring cycle alarms
CYCLE109 Internal subroutine: Data transfer
CYCLE110 Internal subroutine: Plausibility checks
CYCLE111 Internal subroutine: Measuring functions
CYCLE112 Internal subroutine: Measuring functions
CYCLE113 Internal subroutine: Log
CYCLE114 Internal subroutine: Load ZO memory,
load WCS wear
Internal subroutine: Load WCS wear
CYCLE115 Internal subroutine: Load ZO memory
CYCLE116 Calculation of center point and radius of a circle
CYCLE117 Internal subroutine: Measuring functions
CYCLE118 Internal subroutine: Log
If the operating area is switched over during the course of the input dialog, the dialog can be
selected again at a later stage with "Cycles" softkey in the extended menu.
Programming is undertaken using CYCLE103.
Programming example: Workpiece probe calibration
CALIBRATE_IN_X_Y
N10 G54 G17 G0 X100 Y80
N15 T9 D1 Z10
N20 CYCLE103
N25 CYCLE976
N50 M30
CALIBRATE_IN_X_Y
12-2
As of SW 4
X
X
X
X
only up to measuring cycles – SW 6.2
only up to measuring cycles – SW 6.2
X
X
;Position probe at the center of the hole
;and select ZO
;Selection of length correction,
;position probe in hole
;The operator can assign the parameters for
calibration cycle CYCLE976 in interactive mode
;Measuring cycle call for calibration in
X-Y plane
;End of program
;Position probe at the center of the hole and
;select ZO
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
As of SW As of SW
4.5 6.2
X
X
X
the
Measuring cycles