Step 7 - Incorporate Files For Measurement Result Display; Step 8 - Incorporate Measuring Cycle Support - Siemens SINUMERIK 840D sl Programming Manual
Measuring cycles
Hide thumbs
Also See for SINUMERIK 840D sl:
- Function manual (2184 pages) ,
- Programming manual (1334 pages) ,
- Commissioning manual (1102 pages)
Table of Contents
Advertisement
10.5.8
Step 7 – incorporate files for measurement result display
• The following files must be incorporated in the HMI-Embedded software for the
• The MZBILDnn.COM files are incorporated packed as MZBILDnn.CO_.
10.5.9
Step 8 – incorporate measuring cycle support
• A tool make_com.bat is supplied for packing the COM files for the measuring cycle
• Sequence:
• Start make_com.bat
• Incorporate the *.co_ files in the HMI-Embedded software (see HMI-Embedded
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
10.5 Commissioning measuring cycles for HMI-Embedded PCU20 powerline
measurement result display.
– HMI_EMB\MCRESULT\MZBILD01.COM
– HMI_EMB\MCRESULT\MZBILD02.COM
– HMI_EMB\MCRESULT\MZBILD03.COM
– HMI_EMB\MCRESULT\MZBILD04.COM
Commands for packing:
– arj a MZBILD01.CO_ MZBILD01.COM
– arj a MZBILD02.CO_ MZBILD02.COM
– arj a MZBILD03.CO_ MZBILD03.COM
– arj a MZBILD04.CO_ MZBILD04.COM
support.
Set-up an empty directory and copy the following files there:
– hmi_emb\mcsupp\*.com
– hmi_emb\tools\arj.exe
– hmi_emb\tools\make_com.bat
Upgrading Instructions).
Start-up (hardware)
10-17
Advertisement
Table of Contents
