Siemens SINUMERIK 840D sl Programming Manual page 458

Data description
9.3 Data for measuring in JOG
File
E_MS_HOL.SPF
E_MS_PIN.SPF
E_MS_POC.SPF
E_MS_SPI.SPF
E_MT_CAL.SPF
E_MT_LEN.SPF
E_MT_RAD.SPF
E_SP_NPV.SPF
When performing a software upgrade, make sure the variable values in the existing DEF files
are kept. Back them up first, if necessary!
Transfer other files
The following files must also be transferred to the control.
File
JOG_MEAS.COM (up to meas. cycles SW 6.2)
COM_FILE.COM (from meas. cycles SW 6.3)
MA_JOG.COM (up to meas. cycles SW 6.2)
COM_FILE.COM (from meas. cycles SW 6.3)
BMP_FILE.ARC (up to measuring cycles SW 6.2)
BMP_FILE.EXE
MC_CST0.ARC or MC_CST1.ARC
(from measuring cycles SW 6.3)
BMP_FILE.EXE contains:
File
BMPJ640.EXE
BMPJ800.EXE
BMPJ1024.EXE
Note
Up-to-date information is provided in the file SIEMENSD.TXT or SIEMENSE.TXT of the
software being supplied.
9-48
Description
To measure a hole
To measure a spigot/shaft
To measure a rectangular pocket
To measure a rectangular spigot
For calibrating a tool measuring probe
For length measurement of a tool
For radius measurement of a tool
Auxiliary cycle for activating the ZO that is active during measurement
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Description
Configuring file for measuring in JOG user
interface
Configuring file for the softkeys for measuring
in JOG in the JOG basic display
Help displays for measuring in JOG
All screens/displays
Description
Aux. displays, resolution 640 · 480
Aux. displays, resolution 800 · 600
Aux. displays, resolution 1024 · 768
Measuring cycles