Call And Return Conditions - Siemens SINUMERIK 840D sl Programming Manual

Measuring Cycles for Turning Machines
6.1 General prerequisites
Cycle
CYCLE109
CYCLE110
CYCLE111
CYCLE113
CYCLE114
CYCLE115
CYCLE117
CYCLE118
The measuring cycle data are defined in the data blocks:
• GUD5.DEF
• GUD6.DEF
6.1.4

Call and return conditions

• D compensation with the data of the calibration tool or the workpiece probe or the tool to
• The permissible tool type for the workpiece probe is type 5xy with cutting edge positions
• No scaling factors <>1 must be active in the frames. Mirroring is permissible in the
• The G functions active before the measuring cycle call are reactivated at the end of the
6-2
Function
Internal subroutine: Data transfer
Internal subroutine: Plausibility checks
Internal subroutine: Measuring functions
Read system date and time Log
Internal subroutine (tool offset)
Internal subroutine (ZO compensation)
Internal subroutine: Measuring functions
Format real values: Log
Note
The measuring cycles with measuring cycles SW 6.2 can only be used with NCK-SW 6.3
and higher.
be measured must be activated in accordance with the measuring variant before a
measuring cycle is called.
SL 5 to 8. Lengths refer to the center of the probe ball.
workpiece measuring cycles except for calibration (condition: MD 10610:
MIRROR_REF_AX =0).
cycle.
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles