Step 3 - Update Bitmaps; Upgrading Measuring Cycles For Hmi-Embedded Pcu20 Powerline - Siemens SINUMERIK 840D sl Programming Manual

Start-up (hardware)
10.7 Upgrading measuring cycles
10.7.3.4 Step 3 – update Bitmaps
Selection "Commissioning", "Machine data", "Display MD"
Set display machine data MD 9021 LAYOUT_MODE = 1.
Turn HMI-Adv off and on again.
Set display machine data MD 9021 LAYOUT_MODE = 0.
Turn HMI-Adv off and on again.
Remark:
If the MD 9021 is set to 1 ("previous design"), then firstly set to 0 ("new design") and then
reset to 1; ⇒ all bitmaps for measuring cycle support and for measuring JOG are updated.
10.7.4

Upgrading measuring cycles for HMI-Embedded PCU20 powerline

Note
Refer to Chapter 10.5.
10-24
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles