Siemens SINUMERIK 840D sl Programming Manual page 422

Data description
9.2 Cycle data
Channel-specific data
_MT_COMP=0
_MT_EC_R[6,5]=(0,...,0)
_MT_EC_L[6,5]=(0,...,0
_JM_I[10]=
(0,1,1,17,100,0,0,0,0,0)
_JM_B[10]=
(0,1,0,0,0,0,0,0,0,0)
_MC_MTL[3]=
(33.3,33.3,33.3)
_MC_SIMSIM=1
_MC_SIMDIFF=0
9-12
Data type Meaning
INTEGER No additional offset of the measurement result display on tool measurement
with rotating spindle (CYCLE971)
REAL User-defined array for offsetting the measurement result on tool radius
measurement and rotating spindle (CYCLE971)
REAL User-defined array for offsetting the measurement result on tool length
measurement and rotating spindle (CYCLE971)
INTEGER INTEGER value field for JOG measurement
no set array number for probes like in ShopMill
•
number of array for workpiece probe is 1
•
number of array for tool probe is 1
•
working plane for measurement in JOG is G17
•
active ZO number on measurement in JOG is 0 (G500)
•
BOOL BOOL value field for JOG measurement
offset in geometry on tool measurement
•
1 measurement attempt
•
retraction from meas. point at same velocity as intermediate positioning
•
no fast measurement feed
•
INTEGER Probe offset during sphere measuring
(only relevant in CYCLE997 for the measurement variant with "determining
the sphere diameter")
Ratio between the tracer length/pin-sphere (ball) radius ($TC_DP6)
Pre-assignment (default) for 3 measuring probes: 100/3
If this variable is not available, then the trigger values are not corrected.
[Array index]: _PRNUM-1
INTEGER 0: Skip measuring cycles during simulation
1: Run measuring cycles during simulation
REAL Value for simulated measuring difference
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles