Hole, Measure Shaft - Cycle_977_979A; Groove, Measure Web - Cycle_977_979B - Siemens SINUMERIK 840D sl Programming Manual

Miscellaneous functions
7.2 Measuring cycle support in the program editor (up to measuring cycles SW 5.4)
7.2.4.9 Hole, measure shaft – CYCLE_977_979A
With CYCLE_977_979A
Softkeys
measuring variants xxx1 and xxx2 of measuring cycles CYCLE977 and CYCLE979 can be
parameterized.
Parameter
Parameter
_MVAR
_SETVAL
_ID
_SZA
_TNUM
_TNAME
_KNUM
_CPA
_CPO
_STA1
_INCA
_PRNUM
7.2.4.10 Groove, measure web – CYCLE_977_979B
With CYCLE_977_979B
Softkeys
measuring variants xxx3 and xxx4 of measuring cycles CYCLE977 and CYCLE979 can be
parameterized.
7-18
→ →
Type Valu Meaning
e
INTEGER Selection: Angular position
977...paraxial measurement / 979...measurement at an angle
INTEGER >0 Measuring variant
REAL Setpoint
REAL Infeed path
REAL Safety zone (for paraxial measurement only)
INTEGER ≥0 Tool number for automatic offset
STRING Tool name with active tool management
INTEGER ≥0 Offset number
D number for measurement/ZO number for calculating zero offset
REAL Center point hole, shaft 1st axis
REAL Center point hole, shaft 2nd axis
REAL Start angle
REAL Incrementing angle
INTEGER >0 Probe number
Only CYCLE979:
the number of measuring points is provided using the thousands
digit;
0...3 measuring points, 1...4 measuring points
→ →
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
Measuring cycles