Measuring A Surface At An Angle - Siemens SINUMERIK 840D sl Programming Manual

1.12.6

Measuring a surface at an angle

CYCLE998 permits correction of the zero offset after measurement of a surface at an angle.
It is still possible to determine the angles on an oblique surface in space.
Workpiece measurement: Angle measurement
Result:
• Actual dimension: Angle
• Deviation: Zero point offset
Workpiece measurement: Two-angle measurement
Result:
• Actual dimension: 2 angle
• Deviation: Zero point offset
Measuring cycles
Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0
1.12 Overview of measuring cycle functions for milling technology
General
1-39