Siemens Sinamics G120 Series Parameter Manual page 92

Parameters
List of Parameters
p0801[0...2] BI: Download parameter set 1 / Dwnl.par.set 1
Access level: 3
Quick comm. NO
Can be changed: T
Min
-
Description: Defines sources of command to start download of parameter set 1 from attached OP.
The first three digits describe the parameter number of the command source, the last digit refers to the bit setting for
that parameter.
Note: Signal of digital input:
0 = No download
1 = Start download parameter set 1 from OP.
p0802 Transfer data from EEPROM / Transf.Drive->Ext
CU240E Access level: 3
Quick comm. NO
Can be changed: -
Min
0
Description: Transfers values from drive to External device when none 0.
Parameter P0010 must be set to 30 for this to be possible.
Values: 0:
1:
Note: Parameter is automatically reset to 0 (default) after transfer.
P0010 will be reset to 0 on successful completion.
p0802 Transfer data from EEPROM / Transf.Drive->Ext
CU240S Access level: 3
CU240S DP
Quick comm. NO
CU240S DP-F
Can be changed: -
CU240S PN
Min
0
Description: Transfers values from drive to External device when none 0.
Parameter P0010 must be set to 30 for this to be possible.
Values: 0:
1:
2:
Note: Parameter is automatically reset to 0 (default) after transfer.
P0010 will be reset to 0 on successful completion.
Ensure that enough space exists on the MMC card before transferring data (8kb).
1-92
Disabled
Start OP Transfer
Disabled
Start OP Transfer
Start MMC Transfer
P-Group: Commands
Active: NO
Max
-
P-Group: Factory settings
Active: NO
Max
1
P-Group: Factory settings
Active: NO
Max
2
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
Data type: Unsigned32
Data set: CDS
Factory setting
0
Data type: Unsigned16
Data set: -
Factory setting
0
Data type: Unsigned16
Data set: -
Factory setting
0