Siemens Sinamics G120 Series Parameter Manual page 91

p0780[0...1] Value y2 of AO scaling / Value y2:AO scal.
Access level: 2
Quick comm. NO
Can be changed: U, T
Min
0
Description: Defines y2 of output characteristic.
Index: [0] = Analog output 0 (AO0)
[1] = Analog output 1 (AO1)
p0781[0...1] Width of AO deadband / AO deadband width
Access level: 2
Quick comm. NO
Can be changed: U, T
Min
0
Description: Sets width of dead-band in [mA] for analog output.
Index: [0] = Analog output 0 (AO0)
[1] = Analog output 1 (AO1)
r0785.0...1 CO/BO: Status word of AO / AO stat Wd
Access level: 2
Unit: -
Description: Displays status of analog output.
Bit 0 indicates that the value of analog output 0 is negative.
Bit 1 indicates that the value of analog output 1 is negative.
Bit field: Bit Signal name
00 Analog output 0 negative
01 Analog output 1 negative
p0800[0...2] BI: Download parameter set 0 / Dwnl.par.set 0
Access level: 3
Quick comm. NO
Can be changed: T
Min
-
Description: Defines source of command to start download of parameter set 0 from attached OP.
The first three digits describe the parameter number of the command source, the last digit refers to the bit setting for
that parameter.
Note: Signal of digital input:
0 = No download
1 = Start download parameter set 0 from OP.
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
P-Group: Terminals
Active: NO
Max
20
P-Group: Terminals
Active: NO
Max
20
P-Group: Terminals
1 signal
Yes
Yes
P-Group: Commands
Active: NO
Max
-
Parameters
List of Parameters
Data type: Floating Point
Data set: -
Factory setting
20
Data type: Floating Point
Data set: -
Factory setting
0
Data type: Unsigned16
Data set: -
0 signal FP
No -
No -
Data type: Unsigned32
Data set: CDS
Factory setting
0
1-91