Siemens Sinamics G120 Series Parameter Manual page 121

p1036[0...2] BI: Enable MOP (DOWN-command) / Enable MOP(DWN)
CU240E Access level: 3
CU240S
Quick comm. NO
Can be changed: T
Min
-
Description: Defines source for motor potentiometer setpoint decrease frequency.
Dependency: When Standard Telegram selected (P0700 = 6, P0922 = Standard Telegram), parameter cannot be changed.
Notice: If this command is enabled by short pulses of less than 1 second, the frequency is changed in steps of 0.1 Hz.
When the signal is enabled longer than 1 second the ramp generator decelerates with the rate of P1048.
p1036[0...2] BI: Enable MOP (DOWN-command) / Enable MOP(DWN)
CU240S DP Access level: 3
CU240S DP-F
Quick comm. NO
Can be changed: T
Min
-
Description: Defines source for motor potentiometer setpoint decrease frequency.
Dependency: When Standard Telegram selected (P0700 = 6, P0922 = Standard Telegram), parameter cannot be changed.
Notice: If this command is enabled by short pulses of less than 1 second, the frequency is changed in steps of 0.1 Hz.
When the signal is enabled longer than 1 second the ramp generator decelerates with the rate of P1048.
p1036[0...2] BI: Enable MOP (DOWN-command) / Enable MOP(DWN)
CU240S PN Access level: 3
Quick comm. NO
Can be changed: T
Min
-
Description: Defines source for motor potentiometer setpoint decrease frequency.
Dependency: When Standard Telegram selected (P0700 = 6, P0922 = Standard Telegram), parameter cannot be changed.
Notice: If this command is enabled by short pulses of less than 1 second, the frequency is changed in steps of 0.1 Hz.
When the signal is enabled longer than 1 second the ramp generator decelerates with the rate of P1048.
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
P-Group: Setpoints
Active: NO
Max
-
P-Group: Setpoints
Active: NO
Max
-
P-Group: Setpoints
Active: NO
Max
-
Parameters
List of Parameters
Data type: Unsigned32
Data set: CDS
Factory setting
19.14
Data type: Unsigned32
Data set: CDS
Factory setting
2090.14
Data type: Unsigned32
Data set: CDS
Factory setting
8890.14
1-121