Siemens Sinamics G120 Series Parameter Manual page 15

p0004 Parameter filter / Parameter filter
CU240S DP-F Access level: 1
Quick comm. NO
Can be changed: U, T
Min
0
Description: Filters parameters according to functionality to enable a more focussed approach to commissioning.
Values: 0:
2:
3:
4:
5:
7:
8:
10:
11:
12:
13:
19:
20:
21:
22:
p0005[0...2] Display selection / Display selection
Access level: 2
Quick comm. NO
Can be changed: C, U, T
Min
2
Description: Selects display for parameter r0000 on OP (drive display).
Example: P0005 = 21: Actual filtered frequency (r0021)
P0005 = 25: Actual output voltage (r0025)
P0005 = 26: Actual filtered DC link voltage (r0026)
P0005 = 27: Actual output current (r0027)
Notice: These settings refer to read only parameter numbers ("rxxxx").
p0006 Display mode / Display mode
Access level: 3
Quick comm. NO
Can be changed: C, U, T
Min
0
Description: Defines mode of display on OP for r0000 (drive display).
Values: 0:
1:
2:
3:
4:
Note: When inverter is not running, the display alternates between the values for "Not Running" and "Running".
Per default, the setpoint and actual frequency values are displayed alternately.
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
All parameters
Inverter
Motor
Speed sensor
Technol. application / units
Commands, binary I/O
AI and AO
Setpoint channel / RFG
Safety functions
Drive features
Motor control
Motor identification
Communication
Alarms / warnings / monitoring
Technology controller
Ready state: setpoint/output frequency. Run: output frequency
Ready state: setpoint. Run: output frequency.
Ready state: P0005/r0020 value. Run: P0005 value
Ready state: r0002/r0020 value. Run: r0002 value
In all states just display P0005
P-Group: -
Active: NO
Max
22
P-Group: -
Active: NO
Max
4000
P-Group: -
Active: NO
Max
4
Parameters
List of Parameters
Data type: Unsigned16
Data set: -
Factory setting
0
Data type: Unsigned16
Data set: DDS
Factory setting
21
Data type: Unsigned16
Data set: -
Factory setting
2
1-15