Siemens Sinamics G120 Series Parameter Manual page 127

p1074[0...2] BI: Disable additional setpoint / Disab.add.setp
Access level: 3
Quick comm. NO
Can be changed: U, T
Min
-
Description: Disables additional setpoint
p1075[0...2] CI: Additional setpoint / Add. setpoint
Access level: 3
Quick comm. NO
Can be changed: T
Min
-
Description: Defines source of the additional setpoint (to be added to main setpoint).
p1076[0...2] CI: Additional setpoint scaling / Add. setp.scal
Access level: 3
Quick comm. NO
Can be changed: T
Min
-
Description: Defines source of scaling for additional setpoint (to be added to main setpoint).
r1078 CO: Total frequency setpoint / Tot. freq.setp
Access level: 3
Unit: [Hz]
Displays sum of main and additional setpoints in [Hz].
Description:
r1079 CO: Selected frequency setpoint / Sel. freq.setp
Access level: 3
Unit: [Hz]
Description: Displays selected frequency setpoint.
Following frequency setpoints are displayed:
• r1078 Total frequency setpoint
• P1058 JOG frequency right
• P1059 JOG frequency left
Dependency: P1055 (BI: Enable JOG right) or P1056 (BI: Enable JOG left) define command source of JOG right or JOG left
respectively.
Note: P1055 = 0 and P1056 = 0 ==> Total frequency setpoint is selected.
© Siemens AG 2007 All Rights Reserved
SINAMICS G120 Control Units CU240S, Edition 05/2007
P-Group: Commands
Active: NO
Max
-
P-Group: Setpoints
Active: NO
Max
-
P-Group: Setpoints
Active: NO
Max
-
P-Group: Setpoints
P-Group: Setpoints
Parameters
List of Parameters
Data type: Unsigned32
Data set: CDS
Factory setting
0
Data type: Unsigned32
Data set: CDS
Factory setting
0
Data type: Unsigned32
Data set: CDS
Factory setting
1
Data type: Floating Point
Data set: -
Data type: Floating Point
Data set: -
1-127