Rep 18.1.3 Lvps - Xerox WorkCentre 5021 Service Documentation

REP 18.1.3 LVPS

Parts List on PL 18.1
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
Static electricity may damage electrical parts.
Static electricity may damage electrical parts. Always wear a wrist band during servicing. If a
wrist band is not available, touch some metallic parts before servicing to discharge the static
electricity.
Do not get yourself hurt by a soldered portion on the back of the PWB.
1. Remove the Rear Cover. (REP 19.2.1)
2. Remove the Docking Bracket. (Figure 1)
(1) Remove the Docking Screw.
(2) Remove the Docking Bracket.
Figure 1 j0lj41806
3. Remove the Rear Lower Cover. (Figure 2)
(1) Remove the screw (x2).
(2) Remove the Rear Lower Cover.
Initial Issue
WorkCentre 5021/5019
WARNING
CAUTION
CAUTION
4. Disconnect the connector of the LVPS. (Figure 3)
(1) Disconnect the connector (x4).
5. Remove the LVPS. (Figure 4)
(1) Remove the screw (x5).
(2) Remove LVPS.
08/2012
4-53
Figure 2 j0lj41807
Figure 3 j0lj41808
Repairs and Adjustments
REP 18.1.3