Xerox WorkCentre 5021 Service Documentation page 184

(1) Remove the KL-Clip.
(2) Remove the Bearing.
Figure 8 j0lj45638
15. Remove the bearing at the rear and remove the DADF Takeaway Roll. (Figure 9)
(1) Remove the E-Clip.
(2) Remove the Bearing.
(3) Remove the DADF Takeaway Roll.
Figure 9 j0lj45639
Replacement
1. To install, carry out the removal steps in reverse order.
2. When installing the Bracket and Ground Plate, install the Ground Plate as shown in the
figure.
(Figure 10)
Repairs and Adjustments
REP 56.10.1
08/2012
4-82
Figure 10 j0lj45640
WorkCentre 5021/5019
Initial Issue