Xerox WorkCentre 5021 Service Documentation page 274

6.1.4 Standard Specification of Host I/F
The standard specification of Host I/F as follows:
Item Description
Host I/F - USB(2.0)
• Apply to Full Speed (12Mbps) and High Speed (480Mbps) according to
USB host version.
• Not apply to Low Speed (1.5Mbps).
NOTE: Foreign I/F: not support
Initial Issue
WorkCentre 5021/5019
Table 1
6.1.5 Operating Modes
The following 4 operating modes are available.
Mode State
Running Mode The data receiving/image creation/recording (printing) operation mode
Ready Mode When the system can enter the Running Mode immediately
Low Power Mode The mode that reduces the power consumption more than the Ready
Mode
Sleep Mode *1 The mode that reduces the power consumption further more than the
Low Power Mode
*1: Applies to the International Energy Star Program.
6.1.5.1 IOT States
The IOT systems are in the following states in each mode.
Running Mode Ready Mode
Fusing System Maintaining the
(Fusing Unit) operating tem-
perature
Recording System Operating state Stop state
(Transfer/Develop-
ment)
ROS Assembly Operating state Stop state
ESS/MCU PWB Operating state Standby
(Reference)
08/2012
6-5
Table 1
Table 2
Low Power Sleep
Mode Mode
Maintaining the Stop state Stop state Stop state
standby tem-
perature
Stop state Stop state Stop state
Stop state Stop state Stop state
Standby Ready to
receive
General Procedures
6.1.4, 6.1.5
Power OFF
Stop state