Rep 3.1.1 Main Drive Motor; Rep 3.1.2 Main Drive Housing - Xerox WorkCentre 5021 Service Documentation

REP 3.1.1 Main Drive Motor

Parts List on PL 3.1
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Remove the Rear Cover. (REP 19.2.1)
2. Remove the Main Drive Motor. (Figure 1)
(1) Disconnect the connector (x2).
(2) Remove the screw (x2).
(3) Remove the Main Drive Motor.
Figure 1 j0lj40301
Replacement
1. To install, carry out the removal steps in reverse order.
Initial Issue
WorkCentre 5021/5019
WARNING

REP 3.1.2 Main Drive Housing

Parts List on PL 3.1
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Remove the Drum Cartridge.
2. Remove the Toner Cartridge.
3. Remove the Front Cover. (REP
4. Remove the Top Cover. (REP
5. Remove the Cartridge Guide.
6. Remove the Fusing Unit. (REP
7. Remove the MSI. (REP 13.1.1)
8. Remove the L/H Cover. (REP
9. Remove the Registration Chute.
10. Remove the Rear Cover. (REP
11. Remove the Registration Roll.
12. Remove the HVPS. (REP 18.1.2)
13. Remove the Fusing Unit Plate. (Figure 1)
(1) Remove the Bind Screw.
(2) Remove the Fusing Unit Plate from the stud.
14. Remove the Fusing Unit Rear Bracket. (Figure 2)
(1) Remove the screw (x2).
08/2012
4-17
WARNING
(REP 8.1.1)
(PL 8.1)
19.1.1)
19.1.2)
(REP 8.2.1)
7.1.1)
14.1.1)
(REP 15.1.1)
19.2.1)
(REP 15.1.2)
Figure 1 j0lj40302
Repairs and Adjustments
REP 3.1.1, REP 3.1.2