Xerox WorkCentre 5021 Service Documentation page 373

Figure 2 j0lj64012
5. After the last paper is output or when the [Stop] button is pressed, [End] will be displayed
on the UI.
6. Pressing the [Clear All] button returns you to the [Chain-Link Number Entry] screen.
General Procedures
6.4.2.13, 6.4.2.14
6.4.2.14 Test Pattern Print
Purpose
Performs copy quality check by printing the Test Pattern in the machine.
Procedure
1. Enter the CE Diag Mode.
2. Input the Chain-Link No. of the Test Pattern to be output and press the [Start] button to
transition to the [Print Test Pattern Settings] screen.
NOTE: The 24 Gradation Density Pattern (998-905 and 998-906) can only be output on
A3.
Chain-Link Type
998-901 Blank Image
998-902 Solid black
998-903 Stripe
998-904 Grid Pattern
998-905 24 Gradation Density Pattern (A3)
(ATCN24KED)
998-906 24 Gradation Density Pattern (A3)
(ATCN24KDI)
3. The default values for the setting screen are - Quantity: 1, Tray 1, and 1 to 1 Sided.
4. Select the [Quantity], [Paper Supply] and [2 to 1 Sided].
NOTE: The Quantity can be specified up to 2 digits, with the maximum of 99.
5. Pressing the [Start] button outputs the test pattern. An animation will be displayed to indi-
cate that it is being output.
08/2012
6-104
Table 1
Overview
Outputs a blank printout.
Outputs a solid black printout.
Outputs a black and white stripes print-
out.
Outputs a grid pattern printout.
Outputs a 24 gradation density pattern
(ATCN24KED) printout.
Outputs a 24 gradation density pattern
(ATCN24KDI) printout.
Figure 1 j0lj64012
WorkCentre 5021/5019
Initial Issue