Xerox WorkCentre 5021 Service Documentation page 280

6.1.11 Environmental Friendliness
6.1.11.1 Energy Star Program, Blue Angel Mark and ErP Lot6
The table below shows the time to enter other mode after operation completion and power con-
sumption in each mode.
Configuration TEC method
Power (Standard)
(kWh/week)
18PPM CPS Platen/Simp (230V) 2.3
20PPM CPS DADF/Dup (230V) 2.5
18PPM CPS Platen/Simp (115V) 2.3
20PPM CPS DADF/Dup (115V) 2.5
Configuration Sleep Mode
Power (BA Std) (W)
18PPM CPS Platen/Simp (230V) -
20PPM CPS DADF/Dup (230V) -
18PPM CPSPlaten/Simp (115V) -
20PPM CPSDADF/Dup (115V) -
Configuration Ready Mode
Power (BA Std) (W)
18PPM CPS Platen/Simp (230V) -
20PPM CPS DADF/Dup (230V) -
18PPM CPS Platen/Simp (115V) -
20PPM CPSDADF/Dup (115V) -
Initial Issue
WorkCentre 5021/5019
Table 1 (Input voltage: AC115V/AC230Vz)
Low Power Mode
(Reference) Power (BA Std)
(W)
1.232 -
1.343 -
1.233 -
1.370 -
Table 2 (Input voltage: AC115V/AC230Vz)
Power (Catalog) Power(W)*1 *3
(W)
3.0 2.5
3.0 2.6
3.0 2.4
3.0 2.5
Table 3 (Input voltage: AC115V/AC230Vz)
Power (Catalog) Power (W)*1 *3
(W)
65 56
65 60
75 65
75 67
• *1: Actual measured power value, which is base of the power value notified to Energy Star
Program.
• *2: Factory default setting.
• *3: Used for Blue Angel Mark acquisition. (Not applicable for this product)
• *4: Used for ErP Lot6 (EMC Class B product for EU) certification. (Not applicable for this
product)
• *5: Measured by Energy Star tesing condition.
Power (Catalog) Power(W)*1 *3
(W)
50 42
50 42
45 40
45 40
Shift time *2 *3 Recovery time
(for BA)*3
1min -
1min -
1min -
1min -
Plug-in Off Mode *4
Power (ErP Std) Power (W)*3
(W)
- -
- -
- -
- -
08/2012
6-11
Shift time *2 *3 Recovery time (for BA)
*3
1min -
1min -
1min -
1min -
Recovery time
(Catalog)*5
30sec
30sec
30sec
30sec
General Procedures
6.1.11