Xerox WorkCentre 5021 Service Documentation page 142

Figure 6 j0lj41310
8. Move the housing to the tip of the shaft. (Figure 7)
(1) Remove the Bearing.
(2) Remove the KL-Clip.
(3) Move the housing in the direction of the arrow until it is at the tip of the shaft.
Figure 7 j0lj41311
9. Remove the MSI Feed Roll. (Figure 8)
(1) Remove the gear.
(2) Remove the MSI Feed Roll.
Repairs and Adjustments
REP 13.3.1
Replacement
1. To install, carry out the removal steps in reverse order.
2. When installing the MSI Feed Clutch, align the Cutout of the MSI Feed Clutch to the Tab.
(Figure 9)
3. When installing the MSI Top Cover, store the Link in the Guide of the MSI Top Cover. (Fig-
ure 10)
• After installing the MSI Top Cover, check and make sure that the Link is at the posi-
tion shown in the figure from the hole of the MSI Top Cover.
08/2012
4-40
Figure 8 j0lj41312
Figure 9 j0lj41313
WorkCentre 5021/5019
Initial Issue