Xerox WorkCentre 5021 Service Documentation page 334

Chain-Link NVM Name
752-406 PRC_EMPTY_CHECK_START_ATC_MOD_TARG
ET
752-414 PRC_CORR_BUFFER_EMPTY_CHECK_CNT
752-440 PRC_1_TO_2_PV_CNT_PRE
752-441 PRC_1_TO_2_PV_CNT
752-473 PRC_TONER_REST
752-482 PRC_RECOVERY_CNT
752-527 PRC_DISP_MOTOR_FAIL_FLAG
752-535 PRC_SEAL_DETECT_FLAG
752-538 PRC_DELTA_ATC_TARGET_SETUP_CORR
752-556 PRC_REAL_TEMP
752-557 PRC_RECOERY_RETRY_CNT
752-750 PRC_DELTA_VH_PR2
752-765 PRC_DELTA_VB_PR
752-766 PRC_DELTA_VB
Initial Issue
WorkCentre 5021/5019
Table 1 NVM PROCON
Setting Setting
Range Range
(Minimum (Maximum Default
Value) Value) Value
0 999 0
-30000 30000 0
0 4294967295 0
0 4294967295 0
0 100 100
0 255 0
0 1 0
0 1 0
-128 127 0
-50 110 0
0 255 0
-1000 1000 0
-255 255 0
-255 255 0
08/2012
6-65
Write Initialization
Yes/No Yes/No Description
Enable Enable The ATC Correction Target Value at the start of
empty detection
Enable Enable Correction Buffer empty detection count
Enable Enable 1 to 2 PV count_previous
Enable Enable 1 to 2 PV count
Enable Enable Remaining Toner %
Enable Enable Recovery count
Enable Enable DispenseFailFlag
0: Has not occurred
1: Yes
Enable Enable Seal Not Pulled Off Detection Flag
Enable Enable Delta ATC Target Setup Correction Amount
Enable Enable The actual temperature
Enable Enable Recovery retry count
Enable Enable Delta VHpr2
Enable Enable Delta VBpr
Enable Enable Delta VB
General Procedures
6.3.14