Xerox WorkCentre 5021 Service Documentation page 376

6.4.3 Error Display during Diag
Overview
• The error displays that may appear when performing the various Diag functions are as fol-
lows.
Diag Function Error Display
Refer to NVM Err E-2
Err E-4
NVM Settings Err E-2
Err E-4
Err E-5
Err E-6
Initialize NVM Err E-2
Err E-7
Shutdown History Err E-4
Jam Counter Reset Err E-2
Err E-4
HFSI Counter Reset Err E-2
Err E-4
Analog Monitor Err E-2
Err E-4
Component Check Err E-2
Err E-4
Tone Up/Down Err E-4
ATC Sensor Read Err E-4
READ TEMPERTURE Err E-4
Initial Issue
WorkCentre 5021/5019
Meaning
The Chain-Link # that was input is incorrect/an unused Chain-Link #/for an option that is not installed
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
The Chain-Link # that was input is incorrect/an unused Chain-Link #/for an option that is not installed
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
The Chain-Link # that was input is for an item that cannot be changed
The value that was input is out of the valid range
The Chain-Link # that was input is incorrect/an unused Chain-Link #/for an option that is not installed
Failed to initialize the specified area
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
The Chain-Link # that was input is incorrect/an unused Chain-Link #/for an option that is not installed
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
The Chain-Link # that was input is incorrect/an unused Chain-Link #/for an option that is not installed
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
The Chain-Link # that was input is incorrect/an unused Chain-Link #/for an option that is not installed
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
The Chain-Link # that was input is incorrect/an unused Chain-Link #/for an option that is not installed
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
Unable to perform the function as the parts that are the target for the Diag are malfunctioning, etc.
Table 1
08/2012
6-107
Remarks
General Procedures
6.4.3