Rep 15.1.2 Registration Roll - Xerox WorkCentre 5021 Service Documentation

Figure 8 j0lj41507
Initial Issue
WorkCentre 5021/5019

REP 15.1.2 Registration Roll

Parts List on PL 15.1
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Remove the Drum Cartridge.
2. Remove the Front Cover. (REP
3. Remove the MSI. (REP 13.1.1)
4. Remove the L/H Cover. (REP
5. Remove the Registration Chute.
6. Remove the Rear Cover. (REP
7. Remove the Registration Clutch. (Figure 1)
(1) Release the wire harness from the clamp.
(2) Disconnect the connector.
(3) Remove the wire harness from the Harness Guide.
(4) Remove the E-Clip.
(5) Remove the Registration Clutch and the gear.
08/2012
4-47
WARNING
(REP 8.1.1)
19.1.1)
14.1.1)
(REP 15.1.1)
19.2.1)
Figure 1 j0lj41508
Repairs and Adjustments
REP 15.1.1, REP 15.1.2