Rep 56.9.3 Invert Chute - Xerox WorkCentre 5021 Service Documentation

NOTE: For the type that comes with washer attached to the boss at the rear, be careful so
as to not lose the washer. (Figure 2)
Figure 2 j0lj45648
Replacement
1. To install, carry out the removal steps in reverse order.
Initial Issue
WorkCentre 5021/5019

REP 56.9.3 Invert Chute

Parts List on PL 56.9
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Open the Upper Feeder.
2. Open the Retard Chute.
3. Remove the Invert Chute. (Figure 1)
(1) Remove the Tapping Screw (x2).
(2) Remove the Invert Chute.
Replacement
1. To install, carry out the removal steps in reverse order.
08/2012
4-79
WARNING
Figure 1 j0lj45649
Repairs and Adjustments
REP 56.9.2, REP 56.9.3