Rep 9.1.2 Tray 1 - Xerox WorkCentre 5021 Service Documentation

Figure 4 j0lj40904
Repairs and Adjustments
REP 9.1.1, REP 9.1.2

REP 9.1.2 Tray 1

Parts List on PL 9.1
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
1. Remove the paper from Tray 1.
2. Pull out Tray 1 until the position where it is stopped by the stopper.
3. Remove Tray 1. (Figure 1)
(1) Lift up the front of Tray 1 and free the rear right side of Tray 1.
(2) Free the rear left side of Tray 1 in the direction of the arrow.
Replacement
1. To install, carry out the removal steps in reverse order.
08/2012
4-30
WARNING
Figure 1 j0lj40905
WorkCentre 5021/5019
Initial Issue