Xerox WorkCentre 5021 Service Documentation page 111

Figure 2 j0lj40119
5. Remove the IIT Carriage Belt from the pulley. (Figure 3)
(1) Remove the IIT Carriage Belt from the pulley.
Figure 3 j0lj40121
6. Remove the Carriage Drive and Motor. (Figure 4)
(1) Remove the Tapping Screw (x2). (Separate Display - 1)
(2) The Shaft is shifted and loosen the screw. (Separate Display - 2)
(3) Remove the screw. (Separate Display - 2)
(4) Remove the Carriage Drive and Motor.
(5) Disconnect the connector.
(6) Remove the cable band.
Initial Issue
WorkCentre 5021/5019
7. Remove the Carriage Motor. (Figure 5)
(1) Remove the screw (x2).
(2) Remove the Carriage Motor.
Replacement
1. To install, carry out the removal steps in reverse order.
2. After a replacement, enter the Diag Mode and use [Initialize HFSI Counter] to clear the
HFSI counter.
'Chain Link : 956-802'
08/2012
4-9
Figure 4 j0lj40122
Figure 5 j0lj40123
Repairs and Adjustments
REP 1.4.1