Xerox WorkCentre 5021 Service Documentation page 320

6.3.8 NVM DRIVE & NOHAD
Chain-Link NVM Name
741-001 DRV_MAIN_MOTOR_SPEED
741-002 NOHAD_PRINT_STOP_DELAY
741-003 NOHAD_STBY_MODE_INTVAL
741-004 NOHAD_STBY_MODE_COUNT_THRESHOLD
741-005 NOHAD_STBY_MODE_TEMP_THRESHOLD
741-006 NOHAD_STBY_MODE_SWITCH
741-007 NOHAD_COLD_MODE_TEMP_THRESHOLD
741-008 NOHAD_COLD_MODE_HOLD_TIME
741-027 NOHAD_CONDENSE_SWITCH
741-028 NOHAD_CONDENSE_ENTRY_TEMP_THRESHOLD 0
741-029 NOHAD_CONDENSE_HOLD_TIME
741-030 NOHAD_SMELL_FILTER_SWITCH
741-032 NOHAD_FAN_FAIL_START_TIMER
741-033 NOHAD_FAN_FAIL_SUMPLE_TIME_THRESHOLD
Initial Issue
WorkCentre 5021/5019
Table 1 NVM DRIVE & NOHAD
Setting Setting
Range Range
(Minimum (Maximum Default
Value) Value) Value
1040000 1562000 1301028
15 1800 15
1 20 1
1 20 3
0 800 245
0 1 1
0 300 140
0 180 0
0 1 0
300 120
0 240 90
0 1 0
0 60 6
10 300 48
08/2012
6-51
Write Initialization
Yes/No Yes/No Description
Enable Enable main motor speed
(Unit: Ref CLK)
Enable Enable The time for Fan high speed rotation after printing has
completed.
(Unit: 1 s)
Enable Enable The temperature sampling time for Fusing Fan Tempera-
ture Control.
(Unit: 1 s)
Enable Enable The threshold count for determining the mode transition of
the Fusing Fan Temperature Control.
(Unit: times)
Enable Enable The threshold temperature for determining the mode tran-
sition of the Fusing Fan Temperature Control.
(Unit: 0.1 degrees C)
Enable Enable Fusing Fan Temperature Control Execution Switch
0: Do not perform
1: Perform
Enable Enable The threshold temperature for determining the Fan Low
Temperature Stop Operation.
(Unit: 0.1 degrees C)
Enable Enable The time to maintain the Fan in low speed rotation for Fan
Low Temperature Stop Operation.
(Unit: 1 s)
Enable Enable Condensation Mode Execution Switch
0: Do not perform
1: Perform
Enable Enable The threshold temperature for determining whether to
transition to the Condensation Mode.
(Unit: 0.1 degrees C)
Enable Enable The time where the transition to the Sleep Mode is prohib-
ited after entering the Condensation Mode.
(Unit: min)
Enable Enable Deodorant Filter Availability Switch
0: No Deodorant Filter
1: Deodorant Filter available
Enable Enable The time where Fail Detection is prohibited after the Fan
operation.
(Unit: 1 s)
Enable Enable Fan Fail Signal Accumulated Time
(Unit: 1 s)
General Procedures
6.3.8