Rep 56.2.3 Dadf Pwb - Xerox WorkCentre 5021 Service Documentation

Figure 4 j0lj45609
Replacement
1. To install, carry out the removal steps in reverse order.
Initial Issue
WorkCentre 5021/5019

REP 56.2.3 DADF PWB

Parts List on PL 56.2
Removal
When turning OFF the power switch, check that the 'Data' lamp is OFF and that there is
no Job in progress.
Turn OFF the power switch and make sure that the screen display turns OFF.
Check that the power switch is OFF and unplug the power plug.
Static electricity may damage electrical parts.
Static electricity may damage electrical parts. Always wear a wrist band during servicing. If a
wrist band is not available, touch some metallic parts before servicing to discharge the static
electricity.
Do not get yourself hurt by a soldered portion on the back of the PWB.
1. Remove the DADF Rear Cover.
2. Disconnect the connector. (Figure 1)
(1) Disconnect the connector (x9).
08/2012
4-65
WARNING
CAUTION
CAUTION
(REP 56.2.2)
Figure 1 j0lj45610
Repairs and Adjustments
REP 56.2.2, REP 56.2.3