Programming; Display - Siemens sitrans LU10 Instruction Manual

Programming

Operator programmable features are identified by a Point Number and Parameter
Number. The Point Number refers to the Transducer (vessel) Number, Relay Number, mA
Output Number, or TS-3 Number as identified by the Point Type indicators. Parameter
Numbers have a preset Parameter Value for each Point Number.
Programming is accomplished by altering the preset Parameter Values as required to
obtain the RUN mode operation desired. All operator programmable features are defined
in the Quick Start Parameters, Application Parameters, and Enhancement Parameters
sections of this instruction manual.

Display

In the PROGRAM mode, the Point Type, Point Number, Parameter Number, and Parameter
Value (as well as a variety of other programming information) may be viewed.
Note that many indicators are specific to certain programming conditions and therefore,
all indicators are not displayed at any given time. all indicators are not displayed at any given time all indicators are not displayed at any given time all indicators are not displayed at any given time
Point Type
Transducer
Relay
Analog Output
TS-3
Index
Point in Service
Parameter Number the programmable feature the Parameter Value pertains to.
Point Type
LU SAM Bank
Number
Point Number
Parameter Value
Units
Invalid Entry
Auxiliary Function
Scroll Access Tag
PROGRAM mode
Point in Service
7ML19985AN02
LU SAM Bank Point
Number Number
PROGRAM
mode
the Point Number refers to a Transducer, Relay, mA Output, TS-3, or
Breakpoint.
identifies the LU SAM the Relay Number displayed pertains to.
the Transducer, Relay, mA Output or TS-3 # the Parameter Value pertains to.
the current value of the Parameter Number for the Point Number displayed.
indicates the Parameter Value is displayed in: m, cm, mm, ft, in, or %.
indicates the value entered is questionable.
indicates Auxiliary Function access (applies to only some Parameter
Numbers).
indicates the Parameter Value may be scroll accessed.
indicates the PROGRAM mode is accessed.
indicates the Point Numbers which will be scanned in the RUN mode.
SITRANS LU10 – INSTRUCTION MANUAL
Parameter
Units
Value
Parameter
Invalid Entry
Number
Auxiliary
Function
Scroll Access
Tag
Page 15