Load Analyzer - ABB ACS580 Firmware Manual

272 Parameters
No. Name/Value
36

36 Load analyzer

36.01 PVL signal source
Not selected
Motor speed used
Reserved
Output frequency
Motor current
Reserved
Motor torque
DC voltage
Output power
Reserved
Speed ref ramp in
Speed ref ramp out
Speed ref used
Torque ref used
Freq ref used
Reserved
Process PID out
Other
36.02 PVL filter time
0.00...120.00 s
36.06 AL2 signal source
36.07 AL2 signal scaling
0.00...32767.00
Description
Peak value and amplitude logger settings.
See also section Load analyzer
Selects the signal to be monitored by the peak value logger.
The signal is filtered using the filtering time specified by
parameter 36.02 PVL filter
The peak value is stored, along with other pre-selected
signals at the time, into parameters 36.10...36.15.
The peak value logger can be reset using parameter
Reset loggers. The logger is also reset whenever the signal
source is changed. The date and time of the last reset are
stored into parameters 36.16
None (peak value logger disabled).
01.01 Motor speed used
01.06 Output frequency
01.07 Motor current (page 147).
01.10 Motor torque (page 147).
01.11 DC voltage (page 147).
01.14 Output power (page 148).
23.01 Speed ref ramp input
23.02 Speed ref ramp output
24.01 Used speed reference
26.02 Torque reference used
28.02 Frequency ref ramp output
40.01 Process PID output actual
Source selection (see Terms and abbreviations
Peak value logger filtering time. See parameter
signal source.
Peak value logger filtering time.
Selects the signal to be monitored by amplitude logger 2. The
signal is sampled at 200 ms intervals.
The results are displayed by parameters 36.40...36.49. Each
parameter represents an amplitude range, and shows what
portion of the samples fall within that range.
The signal value corresponding to 100% is defined by
parameter 36.07 AL2 signal
Amplitude logger 2 can be reset using parameter
loggers. The logger is also reset whenever the signal
source or scaling is changed. The date and time of the last
reset are stored into parameters
respectively.
For the selections, see parameter
Defines the signal value that corresponds to 100% amplitude. 100.00
Signal value corresponding to 100%.
(page 135).
time.
and 36.17 respectively.
(page 147).
(page 147).
(page 212).
(page 213).
(page 217).
(page 222).
(page 226).
(page 278).
on page 144). -
36.01 PVL
scaling.
36.50 and 36.51
36.01 PVL signal
Def/FbEq16
Output power
36.09
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
2.00 s
100 = 1 s
Motor torque
36.09 Reset
source.
1 = 1