Macro - ABB ACS580 Firmware Manual

42 Settings, I/O and diagnostics on the control panel
The sections below provide detailed information about the contents of the different
submenus available in the Primary settings menu.


Macro

Use the Macro submenu to quickly set up drive control and reference source by
selecting from a set of predefined wiring configurations.
Note: For detailed information about the available macros, see
page 39.
If you do not wish to use a macro, manually define the settings for Start, stop,
reference. Note that even if you select to use a macro, you can also modify the other
settings to suit your needs.

Motor
Use the Motor submenu to adjust motor-related settings, such as nominal values,
control mode or thermal protection.
Note that settings that are visible depend on other selections, for example vector or
scalar control mode, used motor type or selected start mode.
Three assistants are available: Control mode, Nominal value and ID run (for vector
control mode only).
Control macros on