ABB ACS580 Firmware Manual page 54

50 Settings, I/O and diagnostics on the control panel
Menu item
Communication
setup
Drive control setup
Received data from
master
Send data to master Sets what the drive's fieldbus module sends to the
Description
To set up communication between the drive and
the fieldbus master, define these settings and then
select Apply settings to fieldbus module.
Sets how a fieldbus master can control this drive,
and how the drive reacts if the fieldbus
communication fails.
Sets what the drive's fieldbus module expects to
receive from the fieldbus master (PLC). After
changing these settings, select Apply settings to
fieldbus module.
fieldbus master (PLC). After changing these
settings, select Apply settings to fieldbus
module.
Corresponding
parameter
51 FBA A settings
51.01 FBA A type
51.02 FBA A Par2
51.27 FBA A par refresh
51.31 D2FBA A comm
status
50.13 FBA A control
word
50.16 FBA A status
word
58 Embedded fieldbus
58.01 Protocol
58.03 Node address
58.04 Baud rate
58.05 Parity
58.25 Control profile
20.01 Ext1 commands
19.11 Ext1/Ext2
selection
22.11 Ext1 speed ref1
28.11 Ext1 frequency
ref1
22.41 Speed ref safe
28.41 Frequency ref
safe
50.03 FBA A comm loss
t out
46.01 Speed scaling
46.02 Frequency scaling
23.12 Acceleration time
1
23.13 Deceleration time
1
28.72 Freq acceleration
time 1
28.73 Freq deceleration
time 1
51.27 FBA A par refresh
58.14 Communication
loss action
58.15 Communication
loss mode
58.16 Communication
loss time
50.13 FBA A control
word
53 FBA A data out
51.27 FBA A par refresh
58.18 EFB control word
03.09 EFB reference 1
50.16 FBA A status
word
52 FBA A data in
51.27 FBA A par refresh
58.19 EFB status word