ABB ACS580 Firmware Manual page 329

No. Name/Value
Enable
95.03 Estimated AC
supply voltage
0...65535 V
95.04 Control board
supply
Internal 24V
External 24V
95.15 Special HW
settings
Bit Name
0 EX motor
1 ABB Sine filter
2...15 Reserved
0000b...0111b
Description
Adaptive voltage limits enabled.
AC supply voltage estimated by calculation. Estimation is
done every time the drive is powered up and is based on the
rise speed of voltage level of the DC bus while the drive
charges the DC bus.
Voltage.
Specifies how the control board of the drive is powered.
The drive control board is powered from the drive power unit
it is connected to.
The drive control board is powered from an external power
supply.
Contains hardware-related settings that can be enabled and
disabled by toggling the specific bits.
Note: The installation of the hardware specified by this
parameter may require derating of drive output, or impose
other limitations. Refer to the hardware manual of the drive.
Information
1 = The driven motor is an Ex motor provided by ABB for potentially
explosive atmospheres. This sets the required minimum switching
frequency for ABB Ex motors
Notes:
• For non-ABB Ex motors, use parameters
define the correct minimum switching frequency.
• If you have a multimotor system, contact your local ABB
representative.
1 = An ABB sine filter is connected to the output of the drive.
Hardware options configuration word.
Parameters 325
Def/FbEq16
1
-
10 = 1 V
Internal 24V
0
1
-
97.01 and 97.02 to
1 = 1