ABB ACS580 Firmware Manual page 173

No. Name/Value
12.23 AI2 forced value
0.000...20.000 mA
or 0.000...10.000 V
12.25 AI2 unit selection
V
mA
12.26 AI2 filter time
0.000...30.000 s
12.27 AI2 min
0.000...20.000 mA
or 0.000...10.000 V
12.28 AI2 max
0.000...20.000 mA
or 0.000...10.000 V
12.29 AI2 scaled at AI2
min
-32768.000...
32767.000
Description
Forced value that can be used instead of the true reading of
the input. See parameter
Forced value of analog input AI2.
Selects the unit for readings and settings related to analog
input AI2.
Note: In firmware ASCL2 and ASCL4), this setting must
match the corresponding hardware setting on the drive
control unit. chapter Electrical installation, section Switches in
the Hardware manual of the drive and the default control
connections for the macro in use in chapter
(page 59). Control board reboot (either by cycling the power
or through parameter 96.08 Control board
validate any changes in the hardware settings.
Volts.
Milliamperes.
Defines the filter time constant for analog input AI2. See
parameter 12.16 AI1 filter
Filter time constant.
Defines the minimum site value for analog input AI2.
Set the value actually sent to the drive when the analog signal
from plant is wound to its minimum setting.
Minimum value of AI2.
Defines the maximum site value for analog input AI2.
Set the value actually sent to the drive when the analog signal
from plant is wound to its maximum setting.
Maximum value of AI2.
Defines the real value that corresponds to the minimum
analog input AI2 value defined by parameter
(Changing the polarity settings of
effectively invert the analog input.)
AI
scaled
12.101
12.27
Real value corresponding to minimum AI2 value.
12.02 AI force selection.
Control macros
boot) is required to
time.
12.27 AI2
12.29 and 12.101
(12.22)
12.28
12.29
Parameters 169
Def/FbEq16
-
1000 = 1 unit
mA
2
10
0.100 s
1000 = 1 s
4.000 mA or
0.000 V
1000 = 1 unit
20.000 mA or
10.000 V
1000 = 1 unit
0.000
min.
can
AI (12.21)
in
1 = 1