Control Macros - ABB ACS580 Firmware Manual

Term/abbreviation
FENA-01/-11/-21
FEPL-02
FPBA-01
Frame (size)
FSCA-01
ID run
IGBT
Intermediate circuit
Inverter
I/O
LSW
Macro
NETA-21
Network control
Parameter
PID controller
PLC
PROFIBUS,
PROFIBUS DP,
PROFINET IO
PTC
R0, R1, ...
RO
Explanation
Optional Ethernet adapter module for EtherNet/IP, Modbus TCP and
PROFINET IO protocols
Ethernet POWERLINK adapter module
Optional PROFIBUS DP adapter module
Refers to drive physical size, for example R0 and R1. The type
designation label attached to the drive shows the frame of the drive, see
chapter Operation principle and hardware description, section Type
designation label in the Hardware manual of the drive.
Optional RSA-485 adapter module
Motor identification run. During the identification run, the drive will
identify the characteristics of the motor for optimum motor control.
Insulated gate bipolar transistor
See DC link.
Converts direct current and voltage to alternating current and voltage.
Input/Output
Least significant word
Pre-defined default values of parameters in drive control program. Each
macro is intended for a specific application. See chapter
on page 59.
Remote monitoring tool
With fieldbus protocols based on the Common Industrial Protocol
TM
(CIP ), such as DeviceNet and Ethernet/IP, denotes the control of the
drive using the Net Ctrl and Net Ref objects of the ODVA AC/DC Drive
Profile. For more information, see www.odva.org, and the following
manuals:
• FDNA-01 DeviceNet adapter module user's manual (3AFE68573360
[English]), and
• FENA-01/-11/-21 Ethernet adapter module user's manual
(3AUA0000093568 [English]).
User-adjustable operation instruction to the drive, or signal measured or
calculated by the drive
Proportional–integral–derivative controller. Drive speed control is based
on PID algorithm.
Programmable logic controller
Registered trademarks of PI - PROFIBUS & PROFINET International
Positive temperature coefficient, thermistor whose resistance is
dependent on temperature,
Frame (size)
Relay output; interface for a digital output signal. Implemented with a
relay.
Introduction to the manual 11

Control macros