Parameters - ABB ACS580 Firmware Manual

Introduction to the manual
Contents of this chapter
The chapter describes applicability, target audience and purpose of this manual. It
also describes the contents of this manual and refers to a list of related manuals for
more information.
Applicability
The manual applies to the ACS580 standard control program (ASCLX version 1.70.
and ASCDX version 2.00.).
Note: For ACS580 standard control program, there are different firmwares,
depending on the control board construction and frame size.
For frame sizes R0...R5
R6...R9, firmware ASCL4 or ASCD4 is used.
*
Type codes ACS580-01-088A-4 and ACS580-01-106A-4
To check the firmware version of the control program in use, see system information
(select Menu - System info - Drive) or parameter
158) on the control panel.
Safety instructions
Follow all safety instructions.
• Read the complete safety instructions in the Hardware manual of the drive
before you install, commission, or use the drive.
• Read the firmware function-specific warnings and notes before changing
parameter values. These warnings and notes are included in the parameter
descriptions presented in chapter
*
, firmware ASCL2 or ASCD2 is used, and for frames sizes

Parameters

Introduction to the manual 7
1
07.05 Firmware version
on page 143.
(see page