ABB ACS580 Firmware Manual page 335

No. Name/Value
Timed function 1
Timed function 2
Timed function 3
Reserved
Supervision 1
Supervision 2
Supervision 3
Other [bit]
96.13 User set I/O mode
in2
96.16 Unit selection
Bit Name
0 Power unit
1 Reserved
2 Temperature
unit
3 Reserved
4 Torque unit
5...15 Reserved
0000h...FFFFh
96.51 Clear fault and
event logger
Done
Clear
0...1
96.100 Change user pass
code
10000000...
99999999
96.101 Confirm user pass
code
10000000...
99999999
Description
Bit 0 of 34.01 Timed functions status
Bit 1 of 34.01 Timed functions status
Bit 2 of 34.01 Timed functions status
Bit 0 of 32.01 Supervision status
Bit 1 of 32.01 Supervision status
Bit 2 of 32.01 Supervision status
Source selection (see Terms and abbreviations
See parameter 96.12 User set I/O mode
Selects the unit of parameters indicating power, temperature
and torque.
Information
0 = kW
1 = hp
0 = °C
1 = °F
0 = Nm (N·m)
1 = lbft (lb·ft)
Unit selection word.
Clears all events from the drive's fault and event logs.
1 = No action
1 = Clear the loggers.
(Visible when user lock is open)
To change the current user pass code, enter a new code into
this parameter as well as
warning will be active until the new pass code is confirmed.
To cancel changing the pass code, close the user lock without
confirming. To close the lock, enter an invalid pass code in
parameter 96.02 Pass code, activate parameter
Control board boot, or cycle the power.
See also section User lock
New user pass code.
(Visible when user lock is open)
Confirms the new user pass code entered in
user pass code.
Confirmation of new user pass code.
(see page 255).
(see page 255).
(see page 255).
(see page 248).
(see page 248).
(see page 248).
on page 144). -
in1.
96.101 Confirm user pass
96.08
(page 140).
96.100 Change
Parameters 331
Def/FbEq16
18
19
20
21...23
24
25
26
Not selected
0000b
1 = 1
Done
0
1
1 = 1
10000000
code. A
-
-