ABB ACS580 Firmware Manual page 397

Code
Fault / Aux. code
(hex)
5691 Measurement circuit
ADC
5692 PU board powerfail
5693 Measurement circuit
DFF
5696 PU state feedback
5697 Charging feedback
6181 FPGA version
incompatible
6306 FBA A mapping file
6481 Task overload
6487 Stack overflow
64A1 Internal file load
64B2 User set fault
64E1 Kernel overload
6581 Parameter system
65A1 FBA A parameter
conflict
6681 EFB comm loss
Programmable fault:
Communication loss
action
Cause
Measurement circuit fault.
Power unit power supply
failure.
Measurement circuit fault.
State feedback from output
phases does not match control
signals.
Charging feedback signal
missing.
Firmware and FPGA versions
are incompatible.
Fieldbus adapter A mapping
file read error.
Internal fault.
Internal fault.
File read error.
Loading of user parameter set
failed because
• requested set does not exist
• set is not compatible with
control program
• drive was switched off
during loading.
Operating system error.
Parameter load or save failed.
The drive does not have a
functionality requested by
PLC, or requested functionality
has not been activated.
Communication break in
embedded fieldbus (EFB)
58.14
communication.
Fault tracing 393
What to do
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Check the feedback signal coming from
the charging system
Reboot the control unit (using parameter
96.08 Control board boot) or by cycling
power. If the problem persists, contact
your local ABB representative
Contact your local ABB representative.
Reboot the control unit (using parameter
96.08 Control board boot) or by cycling
power. If the problem persists, contact
your local ABB representative
Reboot the control unit (using parameter
96.08 Control board boot) or by cycling
power. If the problem persists, contact
your local ABB representative
Reboot the control unit (using parameter
96.08 Control board boot) or by cycling
power. If the problem persists, contact
your local ABB representative
Ensure that a valid user parameter set
exists. Reload if uncertain.
Reboot the control unit (using parameter
96.08 Control board boot) or by cycling
power. If the problem persists, contact
your local ABB representative
Try forcing a save using parameter
Parameter save manually. Retry.
Check PLC programming.
Check settings of parameter groups
Fieldbus adapter (FBA)
settings.
Check the status of the fieldbus master
(online/offline/error etc.).
Check cable connections to the
EIA-485/X5 terminals 29, 30 and 31 on
the control unit.
96.07
50
and 51 FBA A