Abs Motor Speed Used; Abs Motor Speed; Abs Output Frequency; Abs Motor Torque - ABB ACS580 Firmware Manual

No. Name/Value
Freq ref used
Reserved
Process PID out
Reserved
Temp sensor 1
excitation
Temp sensor 2
excitation
Reserved

Abs motor speed

used
Abs motor speed %

Abs output

frequency
Reserved

Abs motor torque

Abs output power
Abs motor shaft
power
External PID1 out
Reserved
AO1 data storage
AO2 data storage
Other
13.13 AO1 forced value
0.000...22.000 mA /
0.000...11.000 V
13.15 AO1 unit selection
V
mA
Description
28.02 Frequency ref ramp output
40.01 Process PID output actual
The output is used to feed an excitation current to the
temperature sensor 1, see parameter
source. See also section
127).
The output is used to feed an excitation current to the
temperature sensor 2, see parameter
source. See also section
127).

01.61 Abs motor speed used

01.62 Abs motor speed %

01.63 Abs output frequency

01.64 Abs motor torque

01.65 Abs output power

01.68 Abs motor shaft power

71.01 External PID act value
13.91 AO1 data storage
13.92 AO2 data storage
Source selection (see Terms and abbreviations
Forced value that can be used instead of the selected output
signal. See parameter 13.02 AO force
Forced value for AO1.
Selects the unit for readings and settings related to analog
input AO1.
Note: In firmware ASCL2 and ASCL4), this setting must
match the corresponding hardware setting on the drive
control unit. See chapter Electrical installation, section
Switches in the Hardware manual of the drive and the default
control connections for the macro in use in chapter
macros (page 59). Control board reboot (either by cycling the
power or through parameter
required to validate any changes in the hardware settings.
Volts.
Milliamperes.
(page 226).
(page 278).
35.11 Temperature 1
Motor thermal protection
35.21 Temperature 2
Motor thermal protection
(page 149).
(page 149).
(page 149).
(page 149).
(page 149).
(page 149).
((page 315).
(page 176).
(page 176).
on page 144). -
selection.
96.08 Control board
Parameters 171
Def/FbEq16
14
15
16
17...19
20
(page
21
(page
21...25
26
27
28
29
30
31
32
33
34...36
37
38
0.000 mA
1 = 1 unit
mA
Control
boot) is
2
10